Interactive

Screw Peripheral Speed

See how screw rotation becomes circumference travel and peripheral speed.

Process inputs

Live
60 mm
20 mm120 mm
100 RPM
0 RPM240 RPM
Circumference
188.50 mm
Peripheral speed
314.16 mm/s
Equivalent
0.314 m/s
Equivalent
18.85 m/min

Teaching note: the animation speed follows the selected RPM. At very high RPM, the visual motion is intentionally capped so the concept stays readable, while all numerical values remain exact.

Animation stages

Rotating screw end view A circle represents the screw diameter. An orange marker moves around the circumference. D = 60 mm
Step 1

One revolution = one circumference

Follow the orange point on the outside diameter. Every complete revolution makes that point travel once around the screw.

Circumference
C = π × D
C = π × 60 = 188.50 mm
Key idea: RPM tells us how many times this circumference is travelled every minute.
Start Unwrapped circumference = 188.50 mm
Step 2

Unwrap the circular travel

Imagine cutting the circumference at one point and laying it flat. The curved travel becomes a straight distance.

1 rev = π × D mm
For this screw: 1 rev = 188.50 mm
This is the bridge between rotation and linear peripheral travel.
Peripheral surface passing a fixed point 100 RPM
Orange line = fixed reference point on the barrel
Travel each revolution
188.50 mm/rev
Revolutions each minute
100 rev/min
Step 3

Multiply distance per revolution by RPM

πD × RPM = mm/min
188.50 × 100 = 18,849.56 mm/min

Then convert minutes to seconds:

v = (πD × RPM) ÷ 60
18,849.56 ÷ 60 = 314.16 mm/s
Brose m/s: divide mm/s by 1000, or combine both conversions as ÷ 60,000.
↻ Rotational / peripheral motion
← Axial screw retraction
Step 4

Two motions can both be described in mm/s

During metering, the screw rotates and typically retracts axially as material accumulates in front of it. These are different physical motions.

Peripheral speed from rotation
314.16 mm/s
Calculated from diameter and RPM
Axial retraction speed
Separate process quantity
Cannot be calculated from RPM alone
Important: peripheral mm/s ≠ axial screw retraction mm/s.
Step 5

Same RPM, different diameter, different peripheral speed

All three screws below rotate at 100 RPM.

30 mm screw
157.08 mm/s
60 mm screw
314.16 mm/s
90 mm screw
471.24 mm/s
v ∝ D × RPM
At a fixed RPM, increasing diameter increases circumference and therefore increases peripheral speed proportionally.
Process-transfer message: copying the same RPM from one screw diameter to another does not preserve the same peripheral-speed condition. Convert through circumference first.

The complete calculation path

Diameter D → Circumference πD → × RPM → mm/min → ÷ 60 → mm/s
Core equation
v = πD × RPM / 60