Process Development

Cooling Time Calculator

Estimate the initial total cooling time from average wall thickness and mold temperature.

Process Inputs

Enter the average wall thickness and mold temperature for the initial cooling-time estimate.
mm
Average wall thickness must be greater than 0 mm.
Reference range of the formula: 1.0–6.5 mm.
°C
Enter a valid mold temperature.
A +30% correction is applied only when mold temperature is above 60 °C.
Enter both inputs to calculate the initial total cooling time.

Live Results

Initial process setup value before practical cooling-time optimization.
Initial Total Cooling Time
—
s
Mold temperature is above 60 °C. A +30% correction is applied to the base cooling time.

Holding Pressure Portion
—
s
30% of total cooling time
Remaining Cooling Time
—
s
70% of total cooling time
The calculated time is an initial process setup value. Final cooling time must be established later through practical process validation.

Details & Calculation

Review the base formula, temperature correction, and time split.

1. Base cooling time

tbase = d × (1 + 2d)
Enter the average wall thickness to see the calculation.

2. Mold-temperature correction

Tmold ≤ 60 °C → ttotal = tbase
Tmold > 60 °C → ttotal = 1.30 × tbase
Enter the mold temperature to determine whether the correction applies.

3. Holding-pressure portion

thold = 0.30 × ttotal
—

4. Remaining cooling time

tremaining = 0.70 × ttotal
—

5. Time balance

ttotal = thold + tremaining
—

Interpretation

This calculator provides an initial cooling-time setup from average wall thickness and mold temperature. Local thick sections, ribs, bosses, poorly cooled regions, and the actual molded-part response may require additional cooling. The final production setting should be validated practically on the molding machine.